MEDIWET - NOT AVAILABLE
Group Number: 3323
The humidifier for oxygen therapy is a device allowing
an increse in the relative humidity in the oxygen supplied
to the patient; this gas for medical use normally lacks a
sufficient humidity grade to be physiologically tolerated.
The jar is made of polycarbonate, or polysulphone the cap with inlet adaptor
of polypropylene and inlet connection of polypropylene + coated brass.
TECHNICAL DATA
| Contents: | Only sterile water |
| Dimensions: | Height 190 × Width 57 × ∅67 mm |
| Weight: | 145 g |
| Capacity: | 200 ml of water |
| Material: | |
| Polycaronate: | Jar polycarbonate (autoclavable at 121 °C) |
| Polysulphone: | Jar polysulphone (autoclavable at 134 °C) |
| Polypropylene: | Lid and outlet hose nipple: polypropylene |
| Inlet nut: | The brass thread and it is injected to the plastic hand nut |
| Diffuser: | Polyethylene |
| Hose gasket: | Silicone |
| O-ring: | EPDM |
| Outlet connection: | Tapered hose nipple for hose 6 × 9 mm (recommended length 2 m) |
| Cleaning: | Water, non abrasive detergent. Never use solvents. |
| Disinfection: | An alcoholic solution, or other solution compatible with the material according to the disinfectant manufacturer. |
| Autoclave: | Polycarbonate version 121°C for 20 minutes Polysulphone version 134°C for 18 minutes |
| Special case: | |
| Diffuser: | Exchange at every cleaning - do not sterilise! |
| Maintenance: | Check that the humidifier is whole and air tight before use. Monthly exchange of gaskets is recommended. Exchange the diffuser when its microperforations no longer exist. |
| Durability: | Minimum 20 autoclave cycles under the condition that all instructions accompanying the product are adhered. |
Mediwet_leaflet_english.pdf .jpg)
.jpg)
